Viral Pick
Spotted on Reddit: r/BestAliExpressFinds video (u/smart_linux)
As an Amazon Associate, we earn from qualifying purchases.
Anyone who has built a flat-pack wardrobe or a garage shelf knows the moment: one hand holding two boards together, the other trying to drive a screw, and the corner slowly drifting out of square. The clip doing the rounds on Reddit shows a simple steel clamp that slips over the joint, locks both boards at a right angle with one twist of an orange knob, and leaves both hands free to drill.
What Makes It Stand Out
This Amazon UK listing is the same stainless steel design as the clamp in the video: a folded steel body with slotted, sliding jaws and a single threaded knob. Slide it over the corner, wind the knob in, and the boards are pulled tight against a fixed 90-degree face, so you can glue, pin or screw the joint without the panels slipping. The seller says it takes boards from about 6mm to 35mm thick, and from 16mm to 25mm when the two boards are different thicknesses. The open-sided version (this pack of two) leaves the corner exposed so you can drill straight into the joint, and a closed version is on the same listing if you would rather have a box-style corner. It works for cabinets, drawers, shelving, boxes and picture frames.
As an Amazon Associate, we earn from qualifying purchases.
Real Talk
The most common gripe in the reviews is speed: the knob is a long fine thread, so moving the jaw from thin board to thick board takes a lot of turning. Buyers also call these smaller-project clamps. They are great for drawers, boxes, frames and cabinet carcasses, but for big, heavy panels you will want more than two, or a larger clamp alongside them. The clamp in the Reddit clip carries a different brand stamp, so expect the same design rather than the exact same maker.
WORTH IT IF
- You build flat-pack, shelving or cabinets on your own
- Your box and drawer corners keep coming out slightly off
- You are after a practical Christmas gift for a DIYer
SKIP IF
- You want quick-release clamps you can reset in a second
- You mostly work with large, heavy sheet panels
- You need angles other than 90 degrees
As an Amazon Associate, we earn from qualifying purchases.